how install cd-r within my laptop?

how install cd-r within my laptop?

Without seeing your PC, adjectives I can do is offer broad advice:



1) Unplug adjectives the wires.

2) Unscrew the screws that hold the side on the casing.

3) Open it up.

4) CD's usually install from the front, ususally there is room for 2 at the top.

5) Attach a flat gray IDE cable to the CD-R.

6) Attach a molex power plug to the CD-R

7) Screw the CD-R contained by so it won't vibrate loose

8) Put the side posterior on.

9) Reconnect all the outside cable.

10) Ta Daa!
Open the computer remove the old drive and install the different drive in alike place.
1st put the comp somewhere you can get to it . 2.ground yourself using a wrist strap or by touching the power supply on the side 3.find and disconnect the matured cd rom or if you wanna keep it ... let say you want in recent times the cdr ...make sure its set to the proper setting on the put a bet on .. master , slave , cs ... the master is always the later plug on the ide cable .. slave is the middle 1 ... when you plug the IDE cable into the drive .. the red markings other point towards the red wire on the power .. should solitary go within 1 way ... fire up afterwards and see if the bios see it ... then after installing ... run a cdr burning program .. aka nero ect fitting luck and if you need more lend a hand ask ... J